Premium Trolling Motor Mount — ½" Aluminum Plate

The Flux trolling motor mount is a no-compromise mounting plate machined from ½-inch thick aluminum and finished with a durable powder coat. Pre-drilled and tapped to fit all major trolling motor brands — including Minn Kota and MotorGuide — it installs clean and holds fast, whether you're running a bow mount on a bass boat or a center console setup in saltwater.

SKU: SQ0834362 | Price: $375.00

---

What's in the Box

One powder-coated aluminum trolling motor mount, ready to install. No adapters, no shims, no workarounds.

---

Why This Trolling Motor Mount Is Built Different

Most off-the-shelf mounting plates are stamped steel or thin-wall aluminum. They flex, they corrode, and they fail. The Flux mount starts at ½" aluminum stock — material thick enough to take the torque of a full-size motor without deflection. The powder coat seals every surface, making it a legitimate saltwater trolling motor mount rather than a freshwater-only product that starts rusting after one season.

What brands does it fit?

The mounting plate ships with pre-drilled and tapped holes sized for all major brands. If you're running a Minn Kota mounting plate setup or need a MotorGuide mounting plate configuration, this covers both without modification.

Does it work on center consoles?

Yes. The plate is dimensioned to work as a trolling motor mount for center console hulls as well as traditional bow layouts and flat-bottom skiffs. It fits many different boat sizes — has the full fitment details.

Is this considered a custom trolling motor mount?

The plate is a standardized product, but the pre-tapped hole pattern and thick aluminum stock give it the same structural integrity you'd expect from a fully custom trolling motor mount fabricated to order — at a fraction of the lead time.

---

Specs

| Spec | Detail | |---|---| | Material | 6061 aluminum, ½" (0.500") thick | | Finish | Powder coat | | Hole Pattern | Pre-drilled and tapped, fits all major brands | | Compatible Motors | Minn Kota, MotorGuide, and others | | Mount Type | Bow mount trolling motor plate / transom-compatible | | Environment | Freshwater and saltwater rated | | SKU | SQ0834362 |

For reference on why aluminum thickness matters in marine environments, see West Marine's guide to boat hardware corrosion and the Minn Kota installation documentation for motor-side torque specs.

---

How does the powder coat hold up in saltwater?

Powder coat over aluminum creates a sealed barrier against salt spray and UV. Unlike painted steel brackets that chip and corrode at cut edges, the aluminum substrate underneath won't rust even if the finish gets scratched. It's the same reason marine-grade fabricators use aluminum trolling motor hardware over steel on offshore builds.

How long does the mount last?

Aluminum doesn't rust. With powder coat intact — and even if it gets dinged — the structural integrity of a ½" plate isn't going anywhere. This is a buy-once part.

How do I install a bow mount trolling motor plate?

Mounting is straightforward: position the bow mount trolling motor plate at your chosen location, mark through the existing holes, drill, and fasten. The pre-tapped holes accept standard motor foot hardware. See for a step-by-step walkthrough.

---

Related Products

---

Have a Question About This Product?

Reach out to the Flux team directly — . We're engineers, not a call center. If you have an unusual hull geometry or need fitment advice, we'll give you a straight answer.